Bushnell 78-9518 Manual De Usuario

•

  Reflector Telescope Assembly

•

  Equatorial Mount

•

  Variable Height-Hardwood Tripod

•

  4mm, 12mm, 20mm focal length - Eyepieces

.

•

  5 x 24 mm Finderscope w/ focus adjustment

•

  Accessory Tray

•

  3x Barlow

•

  Accessory tray: 3-_” bolts, 6-_” washers, 3-wingnuts

1.  Remove all components from the carton and identify all components. READ THROUGH ASSEMBLY

 
2.  Set-Up Tripod

•

  Select one tripod leg. Loosen 

 and extend the 

Tripod  Leg Middle Section (8).

Tighten the 

 so that the 

 is securely in place. Repeat for  the

remaining two legs.

 

3.  Attach Telescope and Finderscope

•

  Locate  the  pre-assembled

  Telescope  Main  Tube  (15)

  and

 

Loosen  long  bolts  at  the  top  of 

Carefully  remove 

  from 

Position the mount over the 

as shown 

(fig. 2).

 and

secure 

  to 

.  Repeat  on  the

remaining two 

. Once you have attached all 

 to the mount, securely tighten all wing nuts and place

 back into 

.

 Locate the 

  with pre-assembled 

  Remove  the  two  nuts  located  near  the  front  of  the

telescope (closet to the eyepiece) and place the 

and 

over  the  exposed  screws.  The

 should  point  towards  the

 Replace the nuts, and securely tighten

the 

 and 

 in place.

 

1.  Attach Accessory Tray

•

  Locate the 

  Using the accessory tray bolts, wingnuts and washers connect the

Accessory Tray   

to the

  Accessory Tray Braces (9)

. Start with one tripod  leg  and  attach  wingnuts.

Wingnuts  should  be  positioned  beneath  the  accessory  tray.  Do  not  tighten  wingnuts  until  all

 are attached as some adjustments may be required.

 

2.  Attach Control Cables, Counterweight and Eyepieces

•

  Locate the 

Loosen  the  silver  screws  located  at  the  end  of  the 

and attach the

 to the two silver posts found on the 

. The first post is located just above the 

, the second post is located

below the 

 
 
 

18

20

21

22

23

24

25

fig. 1

19

 

fig. 2