Land Pride RTR1558 Manual De Usuario
11
7/22/08
RTR10 & RTR15 Series Rotary Tillers 311-431M
Land Pride
Section 1: Assembly and Set-Up
4.
Secure the tractor’s top link to the tiller top hitch using
a 3/4" diameter hitch pin (supplied by customer).
Adjust tractor top link in order to level the tiller.
a 3/4" diameter hitch pin (supplied by customer).
Adjust tractor top link in order to level the tiller.
5.
Prevent damage to the driveline u-joints by adjusting
the tractor’s 3-Point lift height so that the tiller tines are
not lifted more than 14 inches off the ground.
the tractor’s 3-Point lift height so that the tiller tines are
not lifted more than 14 inches off the ground.
Tractor Hook-Up
Figure 1-4
22248
Rear Deflector
Figure 1-3
2
22250
Rear Deflector Assembly
Refer to Figure 1-3:
1.
Insert u-bolt (#6) through Chain (#1) as shown.
2.
Install 2-nuts (#3) and 2-flat washers (#4) onto
the u-bolt an equal distance from the end.
the u-bolt an equal distance from the end.
3.
Insert u-bolt through deflector shield (#2) and secure
with 2-flat washers (#4), 2-lockwashers (#5) and
2-nuts (#3). Tighten nuts to the correct torque.
with 2-flat washers (#4), 2-lockwashers (#5) and
2-nuts (#3). Tighten nuts to the correct torque.
4.
Attach opposite end of chain (#1) to slot “A”.
Tractor Hook-Up
Refer to Figure 1-4:
!
WARNING
Damaged drivelines could cause serious injury or death.
1.
Some tractors are equipped with multi-speed PTO
ranges. Be certain your tractor PTO is set for 540 rpm.
ranges. Be certain your tractor PTO is set for 540 rpm.
2.
Back tractor up to tiller until lower 3-Point links are
aligned with the hitch clevises on the tiller.
aligned with the hitch clevises on the tiller.
3.
Secure tractor’s 3-Point lower links to the lower hitch
clevises using 7/8" diameter hitch pins.
clevises using 7/8" diameter hitch pins.
IMPORTANT: PTO operation and/or engagement
with unit higher than 14” will damage driveline
components. See Figure 1-4.
with unit higher than 14” will damage driveline
components. See Figure 1-4.