Land Pride RTR1558 Manual De Usuario
20
RTR10 & RTR15 Series Rotary Tillers 311-431M
7/22/08
Land Pride
Section 4: Maintenance and Lubrication
Clutch Disassembly & Assembly
If clutch run-in procedure indicates that one or more of the
friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
NOTE: Before proceeding, secure clutch firmly in a
vise or other clamping device to prevent injury.
vise or other clamping device to prevent injury.
10435
Step 2
Remove backup ring, lock collar,
compression spring, bottom
backup ring, and balls.
compression spring, bottom
backup ring, and balls.
Step 3
Tighten the four hex nuts
uniformly until the clutch pack
and hub are loose.
uniformly until the clutch pack
and hub are loose.
Step 4
Bend all four retaining lugs out on
edge of clutch housing.
edge of clutch housing.
Step 5
Remove thrust plate with
Belleville Springs and lug rings to
access friction disks and hub for
inspection or service.
Belleville Springs and lug rings to
access friction disks and hub for
inspection or service.
2-Plate Disassembly
Step 1
Remove snap ring.
Step 6
Inspect friction disks and hub.
10449
Step 2
Compress Belleville Springs to
the pressure plate by tightening
the four hex nuts and then
placing the assembly into the
clutch housing.
the pressure plate by tightening
the four hex nuts and then
placing the assembly into the
clutch housing.
Step 3
Bend retaining lugs inward over
the Belleville Spring edges to
secure the spring before backing
the four hex nuts off.
the Belleville Spring edges to
secure the spring before backing
the four hex nuts off.
Step 4
With lugs bent in, loosen the four
hex nuts completely to the end of
the threaded studs.
hex nuts completely to the end of
the threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring,
compression spring, lock collar,
and top backup ring.
compression spring, lock collar,
and top backup ring.
Step 7
Install snap ring.
Step 1
Place hub and friction disks into
the housing.
the housing.
2-Plate Assembly