John Deere RT 1149 Manual De Usuario
TROUBLESHOOTING
Troubleshooting - Page 26
Using troubleshooting chart
If you are experiencing a problem that is not listed in this chart, see your Frontier dealer for service.
When you have checked all the possible causes listed and you are still experiencing the problem, see your
Frontier dealer.
When you have checked all the possible causes listed and you are still experiencing the problem, see your
Frontier dealer.
IF CHECK
EXCESSIVE TINE WEAR
EXCESSIVE TINE WEAR
Replace loose or bent tine.
Replace tine when worn to a point.
TILLER BUMPING ON GROUND
Obstacles entangled in tines.
Blades incorrectly mounted with no tine spiral effect.
Tines
fi tted with blunt edge leading.
Broken
tines.
INSUFFICIENT DEPTH OBTAINED
Adjust depth control skids.
Insuffi cient power - use lower tractor speed.
Chain cover on hard soil - further passes required.
Blades rolling over ground - use lower tractor speed.
Adjust depth control on tractor.
TILLED SOIL TOO FINE
Raise leveling board.
Use a faster tractor ground speed.
TILLED SOIL TOO COARSE
Lower leveling board.
Use lower tractor speed.
Wait until soil is drier.
TINES BALLING UP WITH SOIL
Raise leveling board.
Decrease tractor speed.
Ground too sticky for working.
CUTTING TOO DEEP ON ONE SIDE
Tiller not level:
• Level tiller.
• Adjust depth control skid.
NOT OVERLAPPING
Drive closer to last run.
Start in center and go around clockwise.
(Tilled soil to the right of the operator.)