Poulan HDR500M Manual De Usuario

Descargar
Página de 21
19
Immediately prepare your tiller for storage at the end of the 
season or if the unit will not be used for 30 days or more.
WARNING:  Never store the tiller with 
gasoline in the tank inside a build ing 
where fumes may reach an open fl ame 
or spark.  Allow the engine to cool before 
storing in any en clo sure.
TILLER
•         Clean entire tiller (See “CLEANING” in the Maintenance 
section of this manual).
•     Inspect and replace belts, if necessary (See belt re-
 place ment instructions in the Service and Ad just ments 
section of this manual).
•      Lubricate as shown in the Maintenance section of this 
manual.
•     Be sure that all nuts, bolts and screws are securely 
fastened.  Inspect moving parts for damage, break age 
and wear.  Replace if necessary.
•     Touch up all rusted or chipped paint surfaces; sand 
lightly before painting.
ENGINE
FUEL SYSTEM
IMPORTANT
IT IS IMPORTANT TO PREVENT GUM 
DEPOSITS FROM FORMING IN ES SEN TIAL FUEL SYS TEM 
PARTS SUCH AS THE CAR BU RE TOR, FUEL FILTER, FUEL 
HOSE, OR TANK DURING STOR AGE. ALSO, EXPERIENCE 
INDICATES THAT AL 
CO HOL BLENDED FUELS (CALLED 
GASOHOL OR USING ETHA 
NOL OR METHA 
NOL) CAN 
ATTRACT MOIS TURE WHICH LEADS TO SEPA RA TION AND 
FORMATION OF ACIDS DUR 
ING STOR 
AGE. ACIDIC GAS 
CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN 
STOR AGE.
•      Drain the fuel tank.
•     Start the engine and let it run until the fuel lines and 
carburetor are empty.
•         Never use engine or carburetor cleaner products in the 
fuel tank or permanent damage may occur.
•      Use fresh fuel next season.
NOTE:  Fuel stabilizer is an acceptable alternative in mini-
mizing the formation of fuel gum deposits during stor age.  
Add stabilizer to gasoline in fuel tank or stor age container.  
Always follow the mix ratio found on stabilizer container.  
Run engine at least 10 minutes after adding stabilizer to 
allow the stabilizer to reach the carburetor.  Do not drain 
the gas tank and car bu re tor if using fuel stabilizer. 
ENGINE OIL
Drain oil (with engine warm) and replace with clean oil.  (See 
“ENGINE” in the Maintenance section of this man ual).
CYLINDER(S)
•      Remove spark plug.
•      Pour 1 ounce (29 ml) of oil through spark plug hole into 
cylinder.
•     Pull starter handle slowly several times to distribute 
oil.
•      Replace with new spark plug.
OTHER
•      Do not store gasoline from one season to an-
other.  
•     Replace your gasoline can if your can starts to rust.  
Rust and/or dirt in your gasoline will cause problems.
•      If possible, store your unit indoors and cover it to give 
protection from dust and dirt.
•     Cover your unit with a suitable protective cover that 
does not retain moisture.  Do not use plastic.  Plastic 
cannot breathe which allows condensation to form and 
will cause your unit to rust.
IMPORTANT: NEVER COVER TILLER WHILE EN GINE AND 
EX HAUST AREAS ARE STILL WARM. 
STORAGE