Beckett 7600WTM Manual De Usuario

Descargar
Página de 12
AquaSmart Wireless Termperature Module Manual
3
Approvals
This equipment has been tested and found to 
comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation.  This 
equipment generates, uses and can radiate 
radio frequency energy, and if not installed and 
used in accordance with the instructions, may 
cause harmful interference to radio 
communications.  However, there is no 
guarantee that interference will not occur in a 
particular installation.  If this equipment does 
cause harmful interference to radio or television 
reception, which can be determined by turning 
the equipment OFF and ON, the user is 
encouraged to try to correct the interference by 
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the 
equipment and receiver.
Connect the equipment into an outlet on a 
circuit different from that to which the 
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
1.
2.
3.
4.
To satisfy FCC RF Exposure 
requirements for mobile 
and base station transmission devices, a 
separation distance of 20cm (8”) or more 
should be maintained between the antenna 
of this device and persons during operation.  
To ensure compliance, operation at closer 
than this distance is not recommended.
The antenna(s) used for this transmitter must 
not be co-located or operating in conjunction 
with any other antenna or transmitter.
Figure 1 - Outdoor Temperature Reset Curve
High Limit
Setting
Minimum
Reset
Temperature
Low
OAT
High
OAT
RESET 
TEMPERATURE
OUTDOOR  AIR  
TEMPERATURE  
(OAT)
This device complies with Industry Canada 
license - exempt RSS standard(s).  
Operation is subject to the following two 
conditions: (1) This device may not cause 
interference, and (2) this device must 
accept any interference, including 
interference that may cause undesired 
operation of the device.
Le présent appareil est conforme aux CNR 
d’Industrie Canada applicables aux 
appareils radio exempts de licence.  
L’exploitation est autorisée aux deux 
conditions suivantes: (1) l’appareil ne doit 
pas produire de brouillage, et (2) 
l’utilisateur de l’appareil doit accepter tout 
brouillage radioélectrique subi, même si le 
brouillage est susceptible d’en 
compromettre le fonctionnement.