Grizzly G0758 Manual De Usuario
Model G0758 (Mfd. Since 2/14)
-21-
SECTION 4: OPERATIONS
To complete typical operation, operator does
the following:
the following:
1. Examines workpiece to make sure it is suit-
able for cutting/drilling.
2. Puts on personal protective equipment.
3. Securely clamps workpiece to table.
4. With machine disconnected from power,
installs correct tooling.
5. Adjusts headstock height above table.
6. Rotates variable-speed knob to lowest set-
ting.
7. Selects correct gear setting on gearbox.
8. Connects machine to power and presses ON
button and rotates variable-speed knob to
correct spindle speed.
correct spindle speed.
9. Uses downfeed controls or table controls to
perform operation.
10. Presses OFF button and waits for spindle to
completely stop before removing workpiece,
changing tooling, or changing spindle speeds.
changing tooling, or changing spindle speeds.
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and face shield when operating this
machine.
To reduce risk of injury from unexpected
startup of spindle at high speeds, always
rotate variable-speed dial to the lowest set-
ting before starting spindle.