Grizzly G5783 Prospecto

Introduction

Drill in tight places with this

⁄

" reversible angle

drill. Producing up to 1300 RPM, this angle drill
includes a

⁄

" Jacobs

chuck and chuck key. The

large paddle switch also makes this drill easy to
use in any position. Requires 90 PSI of air pres-
sure with 7 CFM of compressor capacity.

Inventory

A. Angle Air Drill ............................................. 1

B. Chuck Key .................................................. 1

C. Hex Wrench 3mm ...................................... 1

Operation

Insert your drill bit up to

⁄

" into the chuck and

tighten with the chuck key. Change the drill direc-
tion  by  pushing  the  reverse  valve  into  the  body
then rotate to lock into position. Connect the drill
to  your  regulated  air  source.  The  hex  wrench  is
included  for  removing  the  screw  (Ref  #55)  that
holds the chuck to the spindle.

MODEL G5783

⁄

" REVERSIBLE

ANGLE AIR DRILL

INSTRUCTION SHEET

Figure 1.

Model G5783.

Figure 2.

Lubricating directly into air fitting.

If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#PC8322 PRINTED IN TAIWAN

INJURY HAZARD!

Always disconnect tool from

air to prevent unexpected

operation during service!

EYE/EAR INJURY HAZARD!

Wear safety glasses and

hearing protection during

use of this tool!

Air drill MUST have 3-4 drops of air tool oil directly
dropped into the air fitting before each use as
shown in

Figure 2. Keep the head gear lubricated

by pumping a small amount light grease into the
ball cap on the head.

DO NOT EXCEED 120 PSI!

Personal injury could

occur.