Festool PD574447 Manual De Usuario

16 

Domino XL DF700

When making butt joint frames, such as cabinet faceframes, 

use pencil lines to lay out the position of the tenons. Use the 

sight gauge on the joiner’s fence to position the joiner over 

the pencil line.

For narrow frame stock, the optional Trim Stop can be used 

to securely hold the workpiece (shown below).

Trim Stop

Bench Dog

When making mitered frames, position the tenon closer to 

the inside corner. This reduces the likelihood of cutting the 

mortise all the way through the workpiece.

For larger frame stock, you may be able to use the stop pins 

for setting the mortise position.
Make sure to securely clamp the workpiece to the bench 

when mortising a mitered joint.

Domino tenons can also be used to strengthen cope and 

stick frame construction too (bottom right picture). This is 

typically found in raised panel door frames.
It is important to note that the two frame pieces overlap, so 

the depth of the mortise needs to be extended. The amount 

that each mortise needs to be extended is one-half the 

amount of overlap.
Example: A typical stile and rail router bit set has a profile 

width (overlap) of 3/8-inch (about 10mm). For a 40mm long 

tenon, instead of plunging 20mm deep, you should increase 

this to 25mm for both workpieces.

Stick Profile

Cope Profile

Overlap