Roland EGX-350 Manual De Usuario
![Roland](https://files.manualsbrain.com/attachments/0f4c16ad543d01443d705a6df0a922f055403287/common/fit/150/50/3f2e1fe174f8814c1395beda0db29618b95ef95d02ed697f721709eb4377/brand_logo.png)
4-6 Cutter Installation Method 3 (Diamond Scraper)
68
Chapter 4 Engraving
➋
Install the solid collet.
➀
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Diameter-4.36 millimeter diamond scrap-
ers cannot be used with the included solid
collet. Provide a dedicated diamond-
scraper collet separately.
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Diameter-4.36 millimeter diamond scrap-
ers cannot be used with the included solid
collet. Provide a dedicated diamond-
scraper collet separately.
➁
Fully tighten the solid collet.
Using two wrenches, tighten the solid
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
2.
Set the lock lever.
Set the lock lever at the or
posi-
tion.
For detailed information about the setting
position for the lock lever, refer to the page
indicated below.
position for the lock lever, refer to the page
indicated below.
☞
P. 82, “The Position of the Lock Lever”
Lock lever
Press down to lower
slightly.
slightly.
Wrench
Spindle unit
Solid collet
Wrench
➀
➁
Wrench