Cisco Systems 2130 Manual De Usuario

Repeat Steps 

 through 

 for the other inner slide rail and appliance chassis bracket.

You are now ready to install the appliance into the 4-post rack.

Proceed to the next section, “

,” to continue the installation.

Lifting the appliance and attaching it to the rack is a two-person job. If needed, use an appropriate lifting 
device. A fully loaded Cisco ADE 2130 and 2140 Series appliance weighs approximately 51.5 lb 
(23.4 kg).

This procedure describes the installation of the outer slide rails to a 4-post threaded-hole rack. If your 
4-post rack uses rectangular holes, ensure that you have the proper adapters in place to secure the slide 
rails to the posts.

To attach the outer slide rails to the rack:

Determine the position on the rack where you want to mount the appliance.

Position the rear-mounting bracket on the outer side of the rear rack post and attach with the 
10-32 x 1/2-inch rack screws.

Align the center end of the outer slide rail to the corresponding hole on the front rack post.

Attach the front-mounting bracket of the outer slide rail to the corresponding holes on the front rack post 
with the 10-32 x 1/2-inch rack screws.

Repeat Steps 

 through 

 for the other outer slide rail.

Proceed to the next section, “

,” to continue the installation.

If you mount the outer slide rails in holes that are not vertically aligned from front to back, you might 
damage the slide rails and your mounting might not be secure.

To install the appliance into the rack:

Extend the inner slide rail until it locks into place.

Position the appliance so that the rear end of the inner slide rail aligns with the front end of the outer 
slide rails.

Slide the appliance into the rack.