Cisco Systems 2130 Manual De Usuario

The Cisco ADE 2130 and 2140 Series appliance undergoes extensive testing before it leaves the factory. 
If you encounter problems, use the information in this appendix to help isolate problems or to eliminate 
the appliance as the source of the problem.

Although an overtemperature or overvoltage condition is unlikely at initial startup, a discussion of 
environmental temperature and voltage monitoring functions is provided in the 

.

The procedures in this chapter assume that you are troubleshooting the initial Cisco ADE 2130 and 2140 
Series appliance startup, and that the appliance is in the original factory configuration. If you have 
removed or replaced components or changed any default settings, the recommendations in this chapter 
might not apply.

This appendix does not cover every possible trouble event that might occur on an appliance but instead 
focuses on those events that are frequently seen by the customer.

This appendix contains the following sections: 

Before and at initial system boot, you should verify the following:

External power cable is connected, and the proper power source is being applied. (See the 

The appliance fan and blower are operating. (See the 

 and 

the 

The appliance software boots successfully.

The adapter cards (if installed) are properly installed in their slots, and each initializes (is enabled 
by the appliance software) without problems.