Lincoln Electric K2447-2 Manual De Usuario
Python-Plus Owner's Manual - Page 3
Drive Roll Installation/Removal
NOTE: Neither of the handles needs to be removed to access the Drive
or Idler Rolls.
1. Pull the Cam Lever away from
the idler roll. This will relieve the
pressure against the drive roll (as
shown in Figure 1).
pressure against the drive roll (as
shown in Figure 1).
2. Align the Drive Roll Removal Tool
(P/N 931-0100) over the fl ats of the
drive roll (as shown in Figure 2).
Hold the torch with one hand or on
a table top, with the other hand give
the Removal Tool a quick snap-turn
in the CLOCKWISE DIRECTION.
drive roll (as shown in Figure 2).
Hold the torch with one hand or on
a table top, with the other hand give
the Removal Tool a quick snap-turn
in the CLOCKWISE DIRECTION.
3. Once the drive roll is loose, continue to spin drive roll in the clockwise
direction to remove the drive roll from the torch.
4. Install a new drive roll on the left-hand threaded shaft. The drive roll will
self-tighten when it is feeding wire.
Idler Roll Installation and Removal
(Reference Figure 3)
(Reference Figure 3)
1. Using a slot type screwdriver, loosen idler screw, taking care not to lose
lock washer under idler roll.
2. Insert new idler roll and lock washer onto screw, insuring that idler groove
is toward top and lock washer is beneath.
3. Tighten.
NOTE: Lock washer must be under idler roll or it will not turn freely.
Cam Lever
Figure 2
Figure 1
Figure 3