Lincoln Electric SVM135-B Manual De Usuario

Observe all Safety Guidelines detailed throughout this manual.

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact the Lincoln Electric
Service Department for technical troubleshooting assistance before you proceed. Call 216-383-2531 or 1-800-833-9353.

-----------------------------------------------------------------------------------------------------------------------------

When the gun trigger is activated,
the drive rolls do not turn.  The arc
voltage is present and the solenoid
is energized.  The STATUS LEDs
are steady green.  

The wire is feeding rough or not
feeding, but the drive rolls are 
turning.

When in CC modes with the
optional “MX” or “MSP” panels, the
output does not energize.

1.  Check plug J3 on the wire drive

control board,  and leads #550
and #551 for loose or faulty con-
nections.  See wiring diagram.

1.  The drive roll pressure may be

incorrect.  Set drive roll pres-
sure.  See 

Operation section in

this manual.

2.  Check for dirty or rusty elec-

trode wire.

3.  Make sure the drive rolls and

wire guides are positioned and
installed correctly.  See 

tion section of this manual.

4.  Check for mechanical restric-

tions in the wire feeding path.

1.  Rotate Volts/Trim encoder knob

at least 45° clockwise.  This is
normal.  See 

Accessories sec-

tion for detailed operation.

1.  Perform the 

Drive Motor Test.

2.  The wire drive control board

may be faulty.

1.  Contact the Lincoln Electric

Service Department, 216-383-
2531 or 1-800-833-9353

(WELD).

1.  Check option panel installation

for loose or faulty connections.