OKI OL610EPS Manual De Usuario

                                                                                                                                                
3. PARTS REPLACEMENT
This section covers the procedures for the assembly, disassembly and installations in the field. This 
section describes the disassembly procedures; for assembly procedures, basically proceed with the 
disassembly procedures in the reverse order.
3.1 Precautions Concerning Parts Replacement Always use good anti-static procedures. (1) Parts 
replacements must be carried out, by first turning the printer power switch off [O] and then removing the 
High Capacity Second Paper Feeder from the printer. (2) Do not disassemble the High Capacity Second 
Paper Feeder if it is operating normally. (3) Establish the extent of disassembly suitable for the purpose 
of the procedure, and do not disassemble any more than necessary. (4) Only specified service tools may 
be used. (5) Disassembly must be carried out according to the prescribed procedures. Parts may be 
damaged if such procedures are not followed. (6) Small parts such as screws and collars can easily be 
lost, therefore these parts should be temporarily fixed in the original location. (7) When handling printed 
circuit boards, do not use gloves, which may generate static electricity. (8) Do not place the printed circuit 
boards directly on the equipment or floor.
Service Tools
Table 3-1 shows the tools required for the replacement of printed circuit boards and units in the field.
Table 3-1 Service Tools

OKI OL600/610ex (96-01-18