OKI OL600E Manual De Usuario

                                                                                                                                                
3.3.1 Upper Cover
(1) With the power switch turned off, unplug the AC power cord from the outlet.
(2) Disconnect the interface cable 1.
(3) Remove two thumb screws 2 and remove the PS board (OL610e/PS) 3.
(4) If a memory board is installed, remove it.
(5) On the OL610e/PS, disconnect the flexible cable 4 from the connector (CN1) 5 of the operator panel 
PCB, and put the cable inside the cover.
(6) Open the stacker cover assembly 6 by pressing the knobs 7 on the left and right sides.
(7) Remove the image drum unit 8.
(8) Remove two screws 9, and open the manual feed guide assy 10. Lift up the front of the upper cover 
11 and release the claws at two locations on the back side. Lift the cover straight up one or two inches, 
rotate the cover about 45 degrees to clear the face-up stacker, then lift the cover completely off of the 
printer (Detail A).

When removing or installing the upper cover, be careful not to damage the cable 4.

OKI OL600/610ex (96-01-18