Samsung SCX-5835NX Manual De Usuario

Network setup_ 30

9.

network setup

This chapter gives you step-by-step instructions for setting up the network connected machine and software.

•

•

•

•

  

You can use network after connecting network cable to a corresponding 

port on your machine. 

You need to set up the network protocols on the machine to use it as your 

network machine. You can set up the basic network settings through the 

machine's control panel.
The following table shows the network environments supported by the 

machine:

There are several programs available to setup the network settings easily in 

network environment. For the network administrator especially, managing 

several machines on the network is possible.

Web server embedded on your network machine server. If you login with 

administrator’s ID and password on the web server, it allows you to:

•

Configure the network parameters necessary for the machine to connect 

to various network environments.

•

Customize machine settings.
(See "Using SyncThru™ Web Service" on page 93.)

This utility program allows you to select a network interface and manually 

configure the IP addresses for use with the TCP/IP protocol. (See "Using 

SetIP Program" on page 95.)

When you connect your machine to a network, you must first configure the 

TCP/IP settings for the machine. After you have assigned and verified the 

TCP/IP settings, you are ready to install the software on each computer on 

the network.

Contact the network administrator if you are not sure how to configure.
You can set up TCP/IP network parameters, follow the steps below:

1. Connect your machine to the network with an RJ-45 Ethernet cable.
2. Turned on the machine.
3. Press Machine Setup on the control panel.
4. Press Admin Setting.
5. When the login message appears, enter password. 

Touch the password input area, then the question marks appears. Use 

the number keypad on the control panel to enter the password. Once the 

password is entered, press OK. (Factory setting:1111)

6. Press the Setup tab > Network Setup.
7. Select TCP/IP Protocol.
8. Press IP Setting.
9. Select Static and then enter IP Address, Subnet Mask and Gateway 

address fields. Touch the input area, then enter addresses by number 

keypad on the control panel.

10. Press OK.

Ethernet 10/100 Base-TX

•

Novell NetWare 5.x, 6.x (TCP/IP Only)

•

Windows 

2000/XP/2003/2008/Vista/7/2008 

Server R2

•

Various Linux OS

•

Mac OS X 10.3 ~ 10.6

•

TCP/IP on Windows 

•

IPP

•

DHCP

•

SNMP

•

BOOTP