Samsung SCX-6555N Series Manual De Usuario
Installing accessories_ 121
installing accessories
Your machine is a full-featured model that has been optimized to meet most of your printing needs. Recognizing that each user
may have different requirements, however, Samsung makes several accessories available to enhance your machine’s capabilities.
may have different requirements, however, Samsung makes several accessories available to enhance your machine’s capabilities.
This chapter includes
•
•
•
•
PRECAUTIONS TO TAKE WHEN INSTALLING
ACCESSORIES
ACCESSORIES
•
Disconnect the power cord
Never remove the control board cover while the power is turned on.
Never remove the control board cover while the power is turned on.
To avoid the possibility of an electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
accessories.
accessories.
•
Discharge static electricity
The control board and internal accessories (network interface card or
memory module) are sensitive to static electricity. Before installing or
memory module) are sensitive to static electricity. Before installing or
removing any internal accessories, discharge static electricity from your
body by touching something metal, such as the metal back plate on any
device plugged into a grounded power source. If you walk around before
device plugged into a grounded power source. If you walk around before
finishing the installation, repeat this procedure to discharge any static
electricity again.
electricity again.
INSTALLING A MEMORY DIMM
Your machine has a dual in-line memory module (DIMM) slot. Use this
DIMM slot to install additional memory.
Your machine has 256 MB of memory which can be expanded to 512 MB.
Your machine has 256 MB of memory which can be expanded to 512 MB.
The order information is provided for optional memory DIMM. (See "Memory
Installing a memory module
1.
Turn the machine off and unplug all cables from the machine.
2.
Open the control board cover by grasping it and slide toward you.
3.
Take out a new memory DIMM from the plastic bag.
4.
Holding the memory module by the edges, align the memory module on
the slot at about a 30-degree tilt. Make sure that the notches of the
the slot at about a 30-degree tilt. Make sure that the notches of the
module and the grooves on the slot fit each other.
5.
Press the memory module into the slot with care until you hear a “click”.
1
control board
cover
cover
The notches and grooves illustrated above may not match those
on an actual DIMM and its slot.
Do not press the memory module strongly or the module may be
damaged. If the module does not seem to fit into the slot properly,
carefully try the previous procedure again.