Samsung SCX-6555N Series Manual De Usuario

Getting Started

You can set up TCP/IP network parameters, follow the steps listed below. 
1.

Make sure your machine is connected to the network with an RJ-45 

Ethernet cable.

Make sure you have turned on the machine.

Press Machine Setup on the control panel.

Press Admin Setting.

When the login message appears, enter password. Touch the password 
input area, then the question marks appears. Use the number keypad on 

the control panel to enter the password. Once the password is entered, 

press OK. (Factory setting:1111)

Press the Setup tab > Network Setup.

Select TCP/IP Protocol.
•

This protocol is widely used in Macintosh 

network environments.

You can select the communication speed for 

Ethernet connections.

Press IP Setting. 

Select Static and then enter IP Address, Subnet Mask and Gateway 

address fields. Touch the input area then, enter addresses by number 
keypad on the control panel.

 

Press OK.

Before you begin, ensure that your system meets the following 
requirements:

http://developer.apple.com/networking/

bonjour/download/

, select the Bonjour program that is appropriate for 

your computer operating system and install the program. This program 
will allow you to set network parameters automatically. Follow the 

instructions in the installation window. This program does not support 

Linux.

Contact the network administrator if you are not sure how to configure.

You can also set up the network settings through the network 

administration programs.

•

: Web-based printer 

management solution for network administrators. SyncThru™ 
Web Admin Service

http://

solution.samsungprinter.com

.

•

: Web server embedded on your 

network print server, which allows you to:

- Configure the network parameters necessary for the machine to 

connect to various network environments.

- Customize machine settings.

- Customize email settings and set up address book for scanning 

to email.

- Customize server settings and set up address book for scanning 

to the FTP or SMB servers.

- Customize printer, copy, and fax settings

•

: Utility program allowing you to select a network interface 

and manually configure the IP addresses for use with the TCP/IP 
protocol. See "Using the SetIP program" on page 30.

Pentium II 400 MHz 

(Pentium III 933 MHz)

64 MB 

(128 MB)

600 MB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(256 MB)

1.5 GB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(512 MB)

1.25 GB to 

2 GB

Pentium IV 3 GHz

512 MB 

(1024 MB)

15 GB

Pentium IV 1 GHz
(Pentium IV 2 GHz)

512 MB 

(2048 MB)

10 GB

Pentium IV 1 GHz 32-

bit or 64-bit processor 

or higher

1 GB 

(2 GB)

16 GB

•

Support for DirectX 9 graphics with 128 MB 
memory(to enable the Aero theme).

•

DVD-R/W Drive

Pentium IV 1 

GHz(x86) or 

1.4GHz(x64) 

processors(2GHz or 

faster)

512 MB 

(2048 MB)

10 GB