Samsung 5935NX Manual De Usuario

Getting started_ 24

8.

getting started

This chapter gives you step-by-step instructions for setting up the USB connected machine and software.

•

•

•

•

•

  

This section shows the steps to set up the hardware, as is explained in the 

Quick Install Guide. Make sure you read the Quick Install Guide first and 

follow the steps below:
1. Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow 

extra space to open covers and trays. 
The area should be well ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

Printing is suitable for altitudes under 1,500 m (4,921 ft). Refer to the 

altitude setting to optimize your printing. (See "Altitude adjustment" on 

page 33.)
Place the machine on a flat, stable surface so that there is no incline 

greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected.

2. Unpack the machine and check all the enclosed items.
3. Remove tape holding the machine securely.
4. Install the toner cartridge.
5. Load paper. (See "Loading paper in the tray" on page 38.)
6. Make sure that all cables are connected to the machine. 
7. Turn the machine on.

Machine software are occasionally updated due to release of new 

operating system and etc. If needed, download the latest version from 

the Samsung website. (www.samsung.com/printer)