Samsung SCX-6322DN Manual De Usuario

14.7   

<Troubleshooting>

Duplex Jam 
Open/Close Door

Paper has jammed 
during duplex 
printing.

Clear the jam. See 
page 14.6.

Login to the network 
server was 
successful. 
However, access to 
the file on the 
network server was 
denied.

Change the server 
settings.

The file name you 
have entered 
already exists.

Enter a different file 
name.

The file names you 
can use are from 
doc001 to doc999. 
However, all file 
names are used 
already.

Delete unnecessary 
files.

The fuser door is not 
securely latched.

Open the rear cover 
and close the fuser 
door until it locks into 
place. 
For the location of the 
fuser door, see 
page 14.4.

When the device is 
unable to locate the 
given address of the 
Global server.

Check the search ID.

This is an error 
message and 
displays when the 
global query size 
has been exceeded.

There are too many 
search results. Refine 
your search by 
entering more letters.
Contact a LDAP 
Server administrator.

When there is a 
authentication fail 
while connecting to 
the global server this 
message displays.

Check the 
authentication 
account and 
password.

This error message 
displays when there 
is a communication 
error between the 
global server and 
the device.

Try again.
Contact a LDAP 
Server administrator.

When no global 
server is configured, 
this message 
displays.

Check the LDAP 
server configuration 
settings. 

When the device is 
unable to find the 
Global server.

Check the LDAP 
server address, The 
LDAP server address 
is incorrect, or the 
server has failed.

You have tried to 
select a group 
location number 
where only a single 
location number can 
be used, such as 
when adding 
locations for a 
Multiple Send 
operation.

Use a speed dial 
number or dial a 
number manually 
using the number 
keypad.

The machine has 
received a fax from 
which is registered 
as a junk fax.

The received fax data 
will be deleted.
Reconfirm junk fax 
setup, see page 10.2.

The server address 
you have entered is 
invalid.

Enter the correct 
server address.

The receiving fax 
machine did not 
answer or the line is 
already engaged.

Try again after a few 
minutes.

Your machine 
cannot connect with 
the receiving fax 
machine or has lost 
contact because of a 
problem with the 
phone line.

Try again. If the 
problem persists, wait 
an hour or so for the 
line to clear and try 
again.
Or, turn the ECM 
mode on. See 
page 10.1.

Low Heat Error 
Cycle Power

There is a problem 
in the fuser unit.

Unplug the power 
cord and plug it back 
in. If the problem 
persists, please call 
for service.

A problem has 
occurred in the LSU 
(Laser Scanning 
Unit).

Unplug the power 
cord and plug it back 
inches. If the problem 
persists, please call 
for service.