Samsung SCX-4321 Manual De Usuario

Copying

4.5

If necessary, customize the copy settings, including 
number of copies, darkness, and original type, by using 
the control panel buttons. See “Setting Copy Options” on 
page 4.3.

: You cannot adjust the copy size using the Reduce/

Enlarge button while Auto Fit copying is enabled.

Press Start to begin copying.

You can copy both sides of the ID Card like a drivers licence to 
a single side of paper. 
When you copy using this feature, the machine prints one side 
of the card on the upper half of the paper and the other side on 
the lower half without reducing the size of the original. 
If the loaded card is larger than the printable area, some 
portions may not be printed.
This special copy feature can be applied only when you place a 
document on the document glass. If a document is detected in 
the ADF, ID Card copying feature does not work.

Place the ID Card to be copied on the document glass and 
close the cover. 

Press Menu until “Copy Feature” appears on the top line of 
the display. 

Press the scroll button (  or  ) until “ID Card Copy” 
displays on the bottom line.

Press Enter to make your selection.

If necessary, customize the copy settings, including 
number of copies, darkness, and original type, by using 
the control panel buttons. See “Setting Copy Options” on 
page 4.3.

Press Start to begin copying.

Your machine begins scanning the front side.

When “Set Backside” displays on the bottom line, open the 
document cover and turn the card over. Close the cover.

: If you press the Stop/Clear button or if no buttons 

are pressed for approximately 30 seconds, the machine 

cancels the copy job and returns to Standby mode.

Press Start again.

This copy feature is available only when you load documents in 
the ADF.

Load the documents to be copied in the ADF.

Press Menu until “Copy Feature” appears on the top line of 
the display. 

Press the scroll button (  or  ) until “2 UP” or “4 UP” 
displays on the bottom line.

Press Enter to make your selection.

If necessary, customize the copy settings, including 
number of copies, darkness, and original type, by using 
the control panel buttons. See “Setting Copy Options” on 
page 4.3.

: You cannot adjust the copy size using the Reduce/

Enlarge button for making a 2 or 4 Up copy.

Press Start to begin copying.

This special copy feature can be applied only when you place a 
document on the document glass. If a document is detected in 
the ADF, the Poster copying feature does not work.

Place the document to be copied on the document glass 
and close the cover.

Press Menu until “Copy Feature” appears on the top line of 
the display. 

Press the scroll button (  or  ) until “Poster” displays on 
the bottom line.

Press Enter to make your selection.

If necessary, customize the copy settings, including 
number of copies, darkness, and original type, by using 
the control panel buttons. See “Setting Copy Options” on 
page 4.3.

: You cannot adjust the copy size using the Reduce/

Enlarge button when making a poster.

Press Start to begin copying.

Your original document is divided into 9 
portions. Each portion is scanned and 
printed one by one in the following 
order:

1

2

3

4

1

2

 2-up copying

4-up copying