Samsung CLX-6200 Manual De Usuario

26 _Getting started

You can set up TCP/IP network parameters, follow the steps listed below. 
1. Make sure your machine is connected to the network with an RJ-45 

Ethernet cable.

2. Make sure you have turned on the machine.
3. Press Menu on the control panel, until you see Network on the bottom 

line of the display. 

4. Press OK to access the menu.
5. Press the left/right arrow until TCP/IP displays. 
6. Press OK.
7. Press the left/right arrow until Static displays.
8. Press OK.
9. Press the left/right arrow until IP Address displays.
10. Press OK.

Enter a byte between 0 and 255 using the number keypad and press the 

left/right arrow  to move between bytes.

Repeat this to complete the address from the 1st byte to the 4th byte.

11. When you have finished, press OK.

Repeat steps 9 and 10 to configure the other TCP/IP parameters: 

subnet mask and gateway address.

Before you begin, ensure that your system meets the following 

requirements:

Your machine supports the following Windows operating systems.

Contact the network administrator if you are not sure how to configure.

You can also set up the network settings through the network 

administration programs. 

•

SyncThru™ Web Admin Service: Web-based printer 

management solution for network administrators. SyncThru™ 

Web Admin Service provides you with an efficient way of 

managing network devices and lets you remotely monitor and 

troubleshoot network machines from any site with corporate 
internet access. Download this program from 

.

•

SyncThru™ Web Service: Web server embedded on your 

network print server, which allows you to:

- Configure the network parameters necessary for the machine to 

connect to various network environments.

- Customize machine settings.

•

SetIP: Utility program allowing you to select a network interface 

and manually configure the IP addresses for use with the TCP/IP 

protocol. See "Using the SetIP program" on page 31.

Pentium II 400 MHz 

(Pentium III 933 MHz)

64 MB 

(128 MB)

600 MB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(256 MB)

1.5 GB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(512 MB)

1.25 GB to 

2 GB

Pentium 4.3 GHz

512 MB 

(1024 MB)

15 GB

•

Internet Explorer 5.0 or higher is the minimum requirement for all 

Windows operating systems.

•

Users who have an administrator right can install the software.

RedHat 8.0 ~ 9.0

Fedora Core 1, 2, 3, 4

Mandrake 9.2 ~ 10.1

SuSE 8.2 ~ 9.2

Pentium IV 1 GHz or higher

256 MB or higher

1 GB or higher

USB interface, 

Network interface

Linux Kernel 2.4 or higher

Glibc 2.2 or higher

CUPS

SANE (For scanner-equipped device only)

•

It is necessary to claim swap partition of 300 MB or larger for 

working with large scanned images.

•

The Linux scanner driver supports the optical resolution at 

maximum.