Samsung CLX-6250 Manual De Usuario

Media and tray_ 6

•

Envelopes with a peel-off adhesive strip or with more than one flap that 

folds over to seal must use adhesives compatible with the machine’s 

fusing temperature about 170°C (338 °F) for 0.1 second. The extra flaps 

and strips might cause wrinkling, creasing, or jams and may even 

damage the fuser.

•

For the best print quality, position margins no closer than 15 mm from 

the edges of the envelope.

•

Avoid printing over the area where the envelope’s seams meet.

To avoid damaging the machine, use only labels designed for use in laser 

machines.

•

When selecting labels, consider the following factors:

-

Adhesives:  The adhesive material should be stable at your machine’s 

fusing temperature about 170°C (338 °F).

-

Arrangement:  Only use labels with no exposed backing between 

them. Labels can peel off sheets that have spaces between the 

labels, causing serious jams.

-

Curl:  Prior to printing, labels must lie flat with no more than 13 mm of 

curl in any direction.

-

Condition:  Do not use labels with wrinkles, bubbles, or other 

indications of separation.

•

Make sure that there is no exposed adhesive material between labels. 

Exposed areas can cause labels to peel off during printing, which can 

cause paper jams. Exposed adhesive can also cause damage to 

machine components.

•

Do not run a sheet of labels through the machine more than once. The 

adhesive backing is designed for only a single pass through the 

machine.

•

Do not use labels that are separating from the backing sheet or are 

wrinkled, bubbled, or otherwise damaged.

•

Do not print on media smaller than 98 mm (3.9 inches) wide or 148 mm 

(5.8 inches) long.

•

In the software application, set margins at least 6.4 mm (0.25 inches) 

away from the edges of the material.

Face up

Face down

Face down

Face up

•

Letterhead/ Preprinted paper must be printed with heat-resistant ink that 

will not melt, vaporize, or release hazardous emissions when subjected 

to the machine’s fusing temperature for 0.1 second. Check your 

machine’s specification to view the fusing temperature about 170°C (338 

°F).

•

Letterhead/ Preprinted paper ink must be non-flammable and should not 

adversely affect machine rollers.

•

Forms and letterhead should be sealed in a moisture-proof wrapping to 

prevent changes during storage.

•

Before you load letterhead/preprinted paper, verify that the ink on the 

paper is dry. During the fusing process, wet ink can come off preprinted 

paper, reducing print quality.

When loading used paper, printed side should be facing up with an uncurled 

edge at the front. If you experience problems with paper feed, turn the paper 

around. Note that print quality is not guaranteed.

•

Used paper must be printed with heat-resistant ink that will not melt, 

vaporize, or release hazardous emissions when subjected to the