Samsung SL-C460FW/XAA Hoja De Datos

13 

If your machine and an access point (or wireless router) support Wi-Fi Protected 

Setup™ (WPS), you can easily configure the wireless network settings by 

pressing the 

 (WPS) button on the control panel without a computer.

 

•

If you want to use the wireless network using the infrastructure mode, 
make sure that the network cable is disconnected from the machine. 
Using the 

 button or entering the PIN from the computer to 

connect to the access point (or wireless router) varies depending on the 
access point (or wireless router) you are using. Refer to the user's guide 
of the access point (or wireless router) you are using.

•

When using the WPS button to set the wireless network, security settings 
may change. To prevent this, lock the WPS option for the current wireless 
security settings. The option name may differ depending on the access 
point (or wireless router) you are using.

 

•

Check if the access point (or wireless router) supports Wi-Fi Protected 
Setup™ (WPS).

•

Check if your machine supports Wi-Fi Protected Setup™ (WPS).

•

Networked computer (PIN mode only)

There are two methods available to connect your machine to a wireless network 

using the 

 (WPS) button on the control panel.

The Push Button Configuration (PBC) method allows you to connect your 

machine to a wireless network by pressing both the 

 (WPS) button on the 

control panel of your machine and the WPS (PBC) button on a Wi-Fi Protected 

Setup™ WPS-enabled access point (or wireless router) respectively.

The Personal Identification Number (PIN) method helps you connect your 

machine to a wireless network by entering the supplied PIN information on a Wi-

Fi Protected Setup™ WPS-enabled access point (or wireless router).

Factory default in your machine is PBC mode, which is recommended for a 

typical wireless network environment.

 

If your machine does not have a display screen, you can enable or disable 
the Wi-Fi Direct feature with the WPS button.

•

Press and hold the 

 (WPS) button on the control panel for about 10- 

15 seconds. Wi-Fi Direct feature turns on.

•

Press and hold the 

 (WPS) button on the control panel for more than 

15 seconds. Wi-Fi Direct feature turns off.

•

To get more information about the Wi-Fi Direct feature, read the "Setting 
the Wi-Fi Direct for mobile printing" on page 183.