OKI PM4410 Manual De Usuario
![OKI](https://files.manualsbrain.com/attachments/746962050649a0feb60a3178c50308424e8c349a/common/fit/150/50/0a52b6498c5909275baef8361703ddfcf89c4a81825ec17b78f572dd7bcc/brand_logo.png)
E-21
Pacemark 4410 Setup Guide
Load Paper
Front Feed Continuous Forms
Paper Specifications: Front Feed
Maximum thickness: 0.031 inches (0.79 mm)
Type
Weight
Width
Single Part
12 to 24 lb. (45 to 90 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
Carbonless
9 to 11 lb. (34 to 41 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
(1 + 9 max.)
Interleaf
9 to 14 lb. (34 to 52.5 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
(1 + 6 max)
9 lb. (34 g/m
2
) carbon
Labels
0.011 inch (0.28 mm) thick
3¼ to 15 inches (83 to 381 mm)
Envelopes
24 lb. (90 g/m
2
) max.
3 to 10 inches (76 to 254 mm)
Card Stock
100 lb. (375 g/m
2
) max.
3 to 8 inches (76 to 203 mm)
* For paper widths less than 5 inches (127 mm), remove the support between the
tractors.
When using paper which is thicker than 7-part carbonless or
its equivalent, you must enter the Menu mode, then go to the
Impact Mode item in the Set-Up group and select High
Impact Copy as the setting.
its equivalent, you must enter the Menu mode, then go to the
Impact Mode item in the Set-Up group and select High
Impact Copy as the setting.
To load front-feed continuous forms:
Preparation
1. Position the printer at the front edge of the support (this promotes the
1. Position the printer at the front edge of the support (this promotes the
unrestricted flow of paper into the printer), then place a stack of
continuous forms below the printer. Recommended height of printer
support, 29.5 inches (750 mm).
continuous forms below the printer. Recommended height of printer
support, 29.5 inches (750 mm).