Samsung CLX-6220 Manual De Usuario

Faxing_ 6

•

Off:  Prints in Normal mode.

•

Long Edge:  Prints pages to be read like a book.

•

Short Edge:  Prints pages to be read by flipping like a note pad.

2

5

3

7. Press OK to save your selection.
8. Press Stop/Clear to return to ready mode.

Since your machine is a multi-tasking device, it can receive faxes while you 

are making copies or printing. If you receive a fax while you are copying or 

printing, your machine stores incoming faxes in its memory. Then, as soon 

as you finish copying or printing, the machine automatically prints the fax. 

Before starting a fax, change the following settings according to your 

original’s status to get the best quality.

The default document settings procedure good results when using typical 

text-based originals. However, if you send originals that are of poor quality, 

or contain photographs, you can adjust the resolution to produce a higher 

quality fax. 

1. Press 

 (Fax) on the control panel.

2. Press Menu on the control panel.
3. Press the up/down arrow to highlight Fax Feature and press OK.
4. Press the up/down arrow to highlight Resolution and press OK.
5. Press the up/down arrow until the option you want is highlighted and 

press OK.

6. Press Stop/Clear to return to ready mode.
Recommended resolution settings for different original document types are 

described in the table below:

Originals with normal sized characters.

Originals containing small characters or thin lines or 

originals printed using a dot-matrix printer.

Originals containing extremely fine detail. Super Fine 

mode is enabled only if the machine with which you are 

communicating also supports the Super Fine resolution.

•

For memory transmission, Super Fine mode is 

not available. The resolution setting is 

automatically changed to Fine

•

When your machine is set to Super Fine 

resolution and the fax machine with which you 

are communicating does not support Super 

Fine resolution, the machine transmits using 

the highest resolution mode supported by the 

other fax machine.

Originals containing shades of gray or photographs.

The resolution setting is applied to the current fax job. To change the 

default setting, see "Change default" on page 2.

You can select the degree of darkness of the original document. 

1. Press 

 (Fax) on the control panel.

2. Press Menu on the control panel.
3. Press the up/down arrow to highlight Fax Feature and press OK.
4. Press the up/down arrow to highlight Darkness and press OK.
5. Press the up/down arrow until the option you want highlights and press 

OK.

6. Press Stop/Clear to return to ready mode.

The darkness setting is applied to the current fax job. To change the 

default setting, see "Change default" on page 2.

You can choose the size to be scanned.

The scan size options may vary between document feeder or scanner 

glass. 

1. Press 

 (Fax) on the control panel.

2. Press Menu on the control panel.
3. Press the up/down arrow to highlight Fax Feature and press OK.
4. Press the up/down arrow to highlight Scan Size and press OK.
5. Press the up/down arrow until the scan size you want highlights and 

press OK.

6. Press Stop/Clear to return to ready mode.

You can set the machine to forward the received or sent fax to other 

destination by a fax, an email or a server. If you are out of office but have to 

receive the fax, this feature may be useful.

When you forward a fax by an email, you must first set the mail server 

and IP address in SyncThru™ Web Service (See "Using SyncThru™ 

Web Service" on page 1).

You can set the machine to forward every fax you sent to another 

destination.