Canon 8335B026 Manual De Usuario

Descargar
Página de 4
3
8
1
2
1
2
2
1
(B)
2
3
4
5
6
8
1
2
7
(A)
Cuando aparezca esta 
pantalla, puntee en 
OK.
Sujete la tapa naranja con los dedos y tire de ella suavemente.
 (A) No presione los laterales si la ranura en forma de Y está bloqueada.
 (B) ¡No tocar!
Abra el panel de control.
Retire el envoltorio 
protector.
Retire totalmente la cinta 
naranja.
Introduzca y empuje hacia abajo el depósito de tinta firmemente hasta que 
encaje en su sitio.
Compruebe que la lámpara de tinta está encendida y coloque el siguiente depósito de tinta.
Compruebe que todas las 
lámparas están encendidas.
Compruebe que la cubierta 
interior está cerrada y 
cierre el panel de control.
 ¡No cierre aún la bandeja de 
salida del papel!
Si aparece un mensaje de 
error, compruebe que los 
depósitos de tinta están 
instalados correctamente.
Cierre la bandeja de salida 
del papel.
La extensión de la bandeja de 
salida se cierra automáticamente.
Al cabo de 
aproximadamente 3 o 4 
minutos, compruebe que 
la pantalla ha cambiado tal 
como se muestra en la 
figura.
Cubierta interior
Los depósitos de tinta deberán instalarse en este soporte.
 No toque el interior hasta que cese el movimiento.
When this screen is 
displayed, tap 
OK.
Hook your fingers under the orange cap and slowly pull it out.
 (A) Do not press the sides when the Y-shaped groove is blocked.
 (B) Do not touch!
Open the Operation Panel.
Remove the protective 
wrap.
Remove the orange tape 
completely.
Insert and push down the ink tank firmly until it snaps into place.
Check that the ink lamp is lit, then install the next ink tank.
Check that all lamps are 
lit.
Check that the Inner Cover 
is closed, then close the 
Operation Panel.
 Don't close the Paper 
Output Tray yet!
If an error message appears, 
check that the ink tanks are 
installed correctly.
Close the Paper Output 
Tray.
The Output Tray Extension 
closes automatically.
After about 3 to 4 minutes, 
check that the screen 
changes as shown in the 
figure.
Inner Cover
The ink tanks will be installed into this holder.
 Do not touch inside until the movement stops.
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES
EN
ES