Canon NP6621 Manual De Usuario
4–15
COPYRIGHT © 1998 CANON INC.
CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
MECHANICAL SYSTEM
III. PICK-UP/FEEDING
SYSTEM
A. Pick-Up Assembly
1. Removing the Pick-Up Roller Unit
1) Remove the lower rear cover.
2) Remove the grip ring
2) Remove the grip ring
q
, and remove the pick-
up clutch
w
.
Reference:
When removing the pick-up clutch, pull it off
after matching the cut-off
When removing the pick-up clutch, pull it off
after matching the cut-off
e
in the gear of the
clutch against the turn stop.
Figure 4-301
3) Pull out the cassettes.
4) Remove the E-ring
4) Remove the E-ring
r
and the bushing
t
; then,
remove the pick-up roller unit
y
.
Figure 4-302
2. Removing the Pick-Up Roller
1) Remove the pick-up roller unit. (See “Removing
the Pick-Up Roller Unit.”)
2) Remove the E-ring
q
, bushing
w
, spacer 1
e
and spacer 2
r
; then, remove the pick-up roller
t
.
Figure 4-303
Caution:
Take care not to lose the pins from its front and
rear.
Take care not to lose the pins from its front and
rear.
3. Points to Note When Installing the
Pick-Up Roller
Install the pick-up roller
q
so that the marking
w
shown in Figure 4-304 is at the rear. (However, the
parallel pin will not fit in the groove.)
parallel pin will not fit in the groove.)
Figure 4-304
1
2
3
5
6
4
4
5
2
1
3
2
1