Planar LC1200R Manual De Usuario
LC1200R User’s Guide
021-0183-00 Rev A
22 of 29
Figure
Figure
Figure
Figure 10
10
10
10
0
200
400
600
800
1000
1200
1400
1600
1
1.5
2
2.5
3
3.5
4
DIM input, volts
B
righ
tn
e
s
s, nit
s
6.3.5
Maximum Brightness Mode
If constant maximum brightness is desired, a jumper may be installed at location JP1 on the
inverter board. The jumper will force the LC1200R to maximum brightness unless the
/DISABLE input is active. Use a 0.1 inch jumper such as Molex, part number 15-29-1024.
inverter board. The jumper will force the LC1200R to maximum brightness unless the
/DISABLE input is active. Use a 0.1 inch jumper such as Molex, part number 15-29-1024.
7
Monitor Performance
7.1
Monitor Luminance
Minimum white-light luminance at the screen center of the Monitor face is 1500 cd/m2 [467 fL,
measured normal to the screen face. Luminance specification applies to the initial luminance, i.e.
prior to additional operation in the end system and after a 10 minute warm up.
measured normal to the screen face. Luminance specification applies to the initial luminance, i.e.
prior to additional operation in the end system and after a 10 minute warm up.
Luminance
min
> 1,500cd/m2 [467 fL]
7.2
Display Contrast
Display contrast is a relationship between luminance
levels and the ability to perceive a luminance difference.
It is expressed as a ratio of ON white – luminance to OFF
black background luminance generated by:
levels and the ability to perceive a luminance difference.
It is expressed as a ratio of ON white – luminance to OFF
black background luminance generated by: