Philips S1D13505 Manual De Usuario
Epson Research and Development
Page 5
Vancouver Design Center
13505SPLT Display Utility
S1D13505
Issue Date: 01/02/02
X23A-B-003-03
Program Messages
ERROR: Did not find a 13505 device.
The HAL was unable to read the revision code register on the S1D13505. Ensure that the S1D13505
hardware is installed and that the hardware platform has been set up correctly.
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL currently supports only one
device.
device.
ERROR: Could not register S1D13505FOA device.
A S1D13505 device was not found at the configured addresses. Check the configuration address
using the 13505CFG configuration program.
using the 13505CFG configuration program.
ERROR: Could not set ?? bit-per-pixel display mode.
This message generally means that the given hardware/software setup violates the timing limitations
described in the S1D13505 Hardware Functional Specification, document number X23A-A-001-xx.
described in the S1D13505 Hardware Functional Specification, document number X23A-A-001-xx.