Hypercom ICE 5700 Manual De Usuario
C h a p t e r 2
Installation Procedures
This section contains important information that will help properly install ICE 5700 terminal.
Power-Up the ICE 5700 Terminal
Use the following procedures to power up the ICE 5700 terminal.
Step-by-Step
To power up the ICE terminal:
1.
Connect the +24 Vdc power cable from the AC Adaptor to the three-pin terminal socket labeled
POWER on the back panel of the ICE 5700 terminal.
POWER on the back panel of the ICE 5700 terminal.
2.
Plug the AC Adaptor into a 110-Volt grounded power receptacle. Be sure the connector is firmly
seated. When the power is connected successfully, the terminal beeps twice and then performs a
self-test and diagnostic routine.
seated. When the power is connected successfully, the terminal beeps twice and then performs a
self-test and diagnostic routine.
Figure 2-1. ICE 5700 power socket
Power socket