Fellowes WB 150 Manual De Usuario

6

Maintenance

Strictly speaking, there is no maintenance required for your machine except occasionally wip-
ing it off with a soft cloth dampened with plain water. You can, however, help extend its life
if you empty the waste drawer regularly to prevent cuttings from interfering with the dies. The
window ' above the drawer enables you to easily keep an eye on its contents.

Troubleshooting 

If you experience a problem with your machine, you may be able to solve it quickly yourself :

• Stuck bar - Your machine is most likely jammed. Follow the jam-clearing procedure at the

end of O p e r a t i o n. 

• Partial last hole - Your sheets are not properly aligned. Adjust the centering of your docu-

ment, as described under O p e r a t i o n.

• C r o o ked punch hole line - The document was not put evenly into the punch entry, or cut-

tings  have  become stuck below  the dies. To release cuttings  into  the waste  drawer,  slide a
ruler or cardboard into the entry and move it back and forth a few times.

• Damaged hole edges - You may be punching too many sheets at one time. Try reducing

the number of sheets per batch.

• Loose pages - The wire is probably not fully closed. Put it back into the wire press and lower

the bar farther than before.

• Difficult to turn pages - The wire has been flattened by too much pressure. Unfortunately,

you cannot salvage the document in this case. Next time make sure you lower the bar with
gentle, continuous pressure and not beyond your document’s wire size. 

If  these  measures  do  not  solve  your  problem,  please  contact  us  through  one  of  the 
many  channels  listed  under  Cust omer  Service.  For  your  safety,  please  do  not  attempt 
to repair your machine.