Senatek LS100 Manual De Usuario
23
3: IP Address Configuration
A valid IP address of the LS100 needs to be assigned before it starts to work in the user's network
environment. A network system administrator may provide the user with this IP address setting
information for the network. The IP address must be unique within the network. Otherwise, the LS100
will not have a valid connection to the network.
Users can choose the desired IP mode out of the three IP operating modes, i.e., Static IP, DHCP and
PPPoE. The factory default IP mode is DHCP mode. Table 3-1 shows the parameter items for IP
configuration.
Table 3-1 IP configuration parameters
IP address
Subnet mask
Subnet mask
Static IP
Default gateway
DHCP
No parameters required
PPPoE username
PPPoE username
PPPoE
PPPoE password
Basic ‘set’ command usage for IP configuration is as follows:
set ip ipmode par1 par2 ...
where,
ipmode: ‘static’ for Static IP / ‘dhcp’ for DHCP / ‘pppoe’ for PPPoE
parameters:
if ipmode = static,
par1 = IP address, par2 = subnet mask, par3 = gateway
if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username, par2 = PPPoE password