Sony SDX-700C Manual De Usuario
12
DR (Disaster Recovery
*
) Mode
To enable DR Mode, set position 1 [Drive Mode] switch to ON.
ON
OFF
OFF
1
2
3
4
5
6
7
8
*
In Disaster Recovery Mode, an SDX-800V series drive enters the DR
Standby Mode 15 seconds after you insert a write-protected tape into the
drive, and all the drive LED blink. If you restart the drive while the LED
are blinking, it starts as a CD-ROM device.
Standby Mode 15 seconds after you insert a write-protected tape into the
drive, and all the drive LED blink. If you restart the drive while the LED
are blinking, it starts as a CD-ROM device.
For details about the Disaster Recovery Mode, refer to the instruction
manual that came with the application software you are using.
manual that came with the application software you are using.
Emulation Mode
*
To enable Emulation Mode, set the position 2 [Drive Mode] switch to ON.
ON
OFF
OFF
1
2
3
4
5
6
7
8
*
Emulation Mode returns the following in the Product Identification field
of Inquiry of a SDX-800V series drive.
of Inquiry of a SDX-800V series drive.
SDX-700C
Data Compression Control DIP switch
Data compression can be selected by DIP switches. Data compression is
enabled while position 7 [DC Control (1)] is ON. Control by host can be
disabled when position 8 [DC Control (2)] is ON.
enabled while position 7 [DC Control (1)] is ON. Control by host can be
disabled when position 8 [DC Control (2)] is ON.
1 DR (Disaster Recovery) Mode (ON)
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7 DC Control (1)
8 DC Control (2)
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7 DC Control (1)
8 DC Control (2)
1 DR (Disaster Recovery) Mode
2 Emulation Mode (ON)
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7 DC Control (1)
8 DC Control (2)
2 Emulation Mode (ON)
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7 DC Control (1)
8 DC Control (2)