Cisco Systems OL-7822-06 Manual De Usuario
4-25
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Connect the Management Interface
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
Apply and Save this configuration? [yes/no]: n
The changes you have just entered would be discarded, are you sure? [yes/no]:y
Setup procedure aborted, no configuration changes made.
Connect the Management Interface
Figure 4-2
Cabling the Management Port
Note
By default, the management port is configured to auto-negotiation enabled.
The SCE 1000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.
Step 1
Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel
of the SCE 1000.
of the SCE 1000.
Step 2
Connect the other end of the Ethernet cable into your management network.
The Link LED on the SCE 1000 management port should light up.
Step 3
Test connectivity. From the host that you intend to use for remote management, ping to the SCE 1000
by typing ping and the SCE 1000 IP address, and pressing Enter (see the example, below).
by typing ping and the SCE 1000 IP address, and pressing Enter (see the example, below).
This verifies that an active connection exists between the specified station and the management port.
EXAMPLE:
The following example displays a typical ping response where the target IP address is 10.1.1.201.
C:\>ping 10.1.1.201
pinging 10.1.1.201 ...
PING 10.1.1.201: 56 data bytes
64 bytes from host (10.1.1.201): icmp_seq=0. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=1. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=2. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=3. time=0. ms
----10.1.1.201 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
LINK RX
Cisco SCE 2
000
Series
4xGBE
TX
RX
MM
TX
LINK RX TX
RX
MM
TX
LINK RX TX
RX
MM
TX
LINK RX TX
RX
MM
TX
GBE-1
SUB
LINE
NET
PWR B STAT
US
PWR A
BYPASS
10/100/
1000
LINK/
ACTIVE
10/100/
1000
LINK/
ACTIVE
GBE-2
SUB LINE/CA
SCADE NET
AUX
CONSOLE
MNG 2
MNG 1
92791
3
2
1