ZyXEL Communications N220 Manual De Usuario

 Chapter 1 Getting Started

N220 User’s Guide

The following table describes the operation of the N220’s LEDs.

This section describes some network applications for the N220. You can either set 
the network type to Infrastructure and connect to an AP or use Ad-Hoc mode 
and connect to a peer computer (another wireless device in Ad-Hoc mode).

To connect to a network via an access point (AP), set the N220 network type to 
Infrastructure (see 

). Through the AP, you can access the 

Internet or the wired network behind the AP.  

Figure 2   Application: Infrastructure 

Table 2   N220 LEDs

Orange

Slow 
Blinking

The N220 is turned on, connected to an AP, and is not 
transmitting or receiving data.

Rapid 
Blinking

The N220 is turned on, connected to an AP, and is 
transmitting or receiving data. It also blinks when the 
WPS feature is being used or a WPS connection is being 
initiated.

Off

The N220 is turned off.