ZyXEL Communications N220 Manual De Usuario

 Chapter 2 Tutorial

N220 User’s Guide

There are three ways to connect the wireless client (the N220) to a network 
without using WPS.

• Configure nothing and leave the wireless client to automatically scan for and 

connect to any available network that has no wireless security configured.

• Manually connect to a network (see 

).

• Configure a profile to have the wireless client automatically connect to a specific 

network or peer computer (see 

This example illustrates how to manually connect your wireless client to an access 
point (AP) configured for WPA-PSK security and connected to the Internet. Before 
you connect to the access point, you must know its Service Set IDentity (SSID) 
and WPA-PSK pre-shared key. In this example, the AP’s SSID is “SSID_Example3” 
and its pre-shared key is “ThisismyWPA-PSKpre-sharedkey”. 

After you install the ZyXEL utility and then insert the wireless client, follow the 
steps below to connect to a network using the Site Survey screen. 

Open the ZyXEL utility and click the Site Survey tab to open the screen shown 
next.

Figure 9   ZyXEL Utility: Site Survey

The wireless client automatically searches for available wireless networks. Click 
Scan if you want to search again. If no entry displays in the Available Network 
List, that means there is no wireless network available within range. Make sure 
the AP or peer computer is turned on, or move the wireless client closer to the AP 
or peer computer. See 

 for detailed field descriptions.