Apple 13-0010--001 Manual De Usuario

both the drive and the controller. Be sure to 

make the connection BEFORE installing the 

controller card into the Apple motherboard.

If you are installing a second disk drive, you 

should connect: the ribbon cable from the second 

drive onto the next set. of pins down on the 

controller card marked “DRIVE 2”, taking the  

same precautions as above.

If you are connecting and third (and fourth) 

drive to an Elite Controller, they would be 

connected to the third and fourth set of pins 

from the top down. Once again, be sure to   

orient pin one correctly.

To install your controller card into the Apple, 

simply plug the card into any slot (except zero) 

in the back of the Apple II motherboard as 

follows:

1. With the power switch OFF, remove the top 

cover from the Apple II computer by lifting from 

the rear edge.

2. Choose a slot which would be correct for your 

application. Most packages which run under   

Apple DOS (or are protected from copying) do not 

care which slot you use for your drives; however 

the more advanced operating systems (like CP/M 

and Apple Pascal) require that your first 

controller card be located in slot six. This has 

made slot six the “standard” slot for a disk 

controller card, so you should consider placing