Cisco Systems 15454M6DC Manual De Usuario
1-24
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 1 Hardware Installation
EIA Installation
Procedure: Install the AMP Champ EIA
Step 1
To remove the lower backplane cover, loosen the five screws that secure it to the ONS 15454 and pull it
away from the shelf assembly.
away from the shelf assembly.
Step 2
Align the AMP Champ cover panel with the backplane and insert and tighten the nine perimeter screws
(P/N 48-0358) at 8-10 lbs.
(P/N 48-0358) at 8-10 lbs.
Step 3
Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
have installed all six AMP Champ cards.
have installed all six AMP Champ cards.
Step 4
To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
of each card at 8-10 lbs.
of each card at 8-10 lbs.
Step 5
Place the AMP Champ fastening plate along the bottom of the cover panel, and hand tighten the two
thumbscrews.
thumbscrews.
Figure 1-19 Installing the AMP CHAMP EIA
44309