Cisco Systems 1550 Manual De Usuario

2-23

Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide

OL-24247-01

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 8

Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.

Figure 2-12

Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly

Step 9

Hand-tighten the bolts and the nut (do not overtighten).

Step 10

Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
(see

) to 13 to 15 ft lbs (17.6 to 20.3 Nm).

Note

The mounting bracket can be adjusted up to 45

to compensate for tilted horizontal streetlight

poles.

Step 11

Continue with

, depending on what you purchased.

Installing 1552E, 1552EU, or 1552I in the Mounting Bracket

Step 1

Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side of the access
point (see

, depending on what you purchased). These bolts are supplied with

pole mount kit. Do not screw the bolt all the way in. Leave a gap of approximately 0.25 inch (0.635 cm).

Pole clamp bracket assembly

Bolt holes

Access point support bolt
(M8 flange nut not shown)

Mounting bracket

281940