Promise Technology J310s Manual De Usuario
VTrak J610s, J310s Product Manual
26
If your PC has two DB9 COM ports, and your J610s or J310s unit has two I/O
modules, you can connect a second null-modem cable and RJ11-to-DB9 serial
data cable the I/O module on the right.
modules, you can connect a second null-modem cable and RJ11-to-DB9 serial
data cable the I/O module on the right.
See “Setting Up Data Cable Connections” on page 20 for an explanation of which
I/O module is the default primary. To verify which I/O module is the default
primary, see “Enclosure Command” on page 34.
I/O module is the default primary. To verify which I/O module is the default
primary, see “Enclosure Command” on page 34.
Connecting the Power
Plug the power cords and switch on both power supplies. When the power is
switched on, the LEDs on the front of the VTrak will light up.
switched on, the LEDs on the front of the VTrak will light up.
Figure 20.VTrak J310s front panel LED display. The J610s is similar
When boot-up is finished and the VTrak is functioning normally:
•
•
The heartbeat LED blinks green once every 3 seconds if one I/O module is
installed, or twice every 3 seconds if two I/O modules are installed.
installed, or twice every 3 seconds if two I/O modules are installed.
•
Power and FRU LEDs display green continuously.
•
I/O module LEDs flash green if there is activity on that connection.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
and a disk drive, and the current condition of the drive.
Power
I/O module-2 activity
FRU Status
Not Used
I/O module-1 activity
Heartbeat