Furuno MU-150C Manual De Usuario

 

11. Fasten cables with the clamps marked with the white arrows in the figure below. 

Connect the power connector to J1 on the pcb 10P3879 as follows: 1, Brown; 3, Orange; 
4, Purple, 6, White.   

12. Fix the rear cover with 14 screws (M4 x 8). (Torque 1.47 ±0.15 Nm; 15 ±1.5 kgm) 
13. Temporarily fasten the cover for the power section and connectors with 10 screws 

(M3 x 8). 

14. Fix four spacers for connectors. (Torque: 0.39 ±0.04 Nm; 4 ±0.4 kgm) 
15. Temporarily fasten the cover for the power section and connectors with six screws   

(M3 x 8). (Torque: 0.78 ±0.08 Nm; 8 ±0.8 kgm) 

16. Fasten two waterproofing nuts. (Torque: 0.76 ±0.02 Nm; 7.8 ±0.2 kgm) 
17. Fasten the cover near the power section and connectors with remaining four screws. 

(Torque: 0.78 ±0.08 Nm; 8 ±0.8 kgm) 

18. Attach the FURUNO logo (supplied) at the cavity in the upper left corner of the display 

unit.