National Instruments 3.21E+04 Manual De Usuario



 National Instruments Corporation

2-1

AT-MIO/AI E Series User Manual

This chapter explains how to install and configure your AT E Series 
board.

You may need to install your software before you install your 
AT E Series board. Refer to the appropriate release notes indicated 
below for specific instructions on the software installation sequence.

If you are using NI-DAQ, refer to the NI-DAQ User Manual for PC 
Compatibles Version 4.9.0 Release Notes. Find the installation section 
for your operating system and follow the instructions given there.

If you are using LabVIEW, refer to your LabVIEW release notes.  After 
you have installed LabVIEW, refer to the NI-DAQ release notes and 
follow the instructions given there for your operating system and 
LabVIEW.

If you are using LabWindows/CVI, refer to your LabWindows/CVI 
release notes. After you have installed LabWindows/CVI, refer to your 
NI-DAQ release notes and follow the instructions given there for your 
operating system and LabWindows/CVI.

If you are a register-level programmer, refer to the AT-MIO E Series 
Register-Level Programmer Manual and the DAQ-STC Technical 
Reference Manual for software configuration information.

      You can install an AT E Series board in any available expansion slot 
in your PC.  However, to achieve best noise performance, you should 
leave as much room as possible between the AT E Series board and 
other boards and hardware.  The following are general installation 
instructions, but consult your PC user manual or technical reference 
manual for specific instructions and warnings.