Cisco Systems 78-16356-01 Manual De Usuario
Chapter 1 Introduction
Ports and Connectors
1-8
Cisco Global Site Selector 4491 Hardware Installation Guide
78-16356-01
Ethernet Connectors
The GSS has two integrated 10/100/1000–megabit-per-second (Mbps) Ethernet
connectors. The Ethernet controller provides an interface for connecting to
10-Mbps, 100-Mbps, or 1000-Mbps networks and supports autonegotitate,
full-duplex, or half-duplex operation on an Ethernet LAN.
connectors. The Ethernet controller provides an interface for connecting to
10-Mbps, 100-Mbps, or 1000-Mbps networks and supports autonegotitate,
full-duplex, or half-duplex operation on an Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the chassis.
(UTP) cable to the RJ-45 connector on the back of the chassis.
Note
The 100BASE-TX/1000BASE-TX Ethernet standard requires that you use
standard four twisted-pair Category 5e cable at lengths up to 328.08 ft. (100 m).
standard four twisted-pair Category 5e cable at lengths up to 328.08 ft. (100 m).
illustrates the pin number assignments for the Ethernet 0 RJ-45 port.
Figure 1-5
Ethernet Port 0 Pin Numbers
Link LED
(green)
Activity (TX/RX)LED
(green)
(green)
97447
8
1