Black Box VideoPlex4 Video Wall Controller Manual De Usuario

724-746-5500 | blackbox.com

Page 15

Chapter 3: Setting Up the VideoPlex4

3. Setting Up the VideoPlex4

• Make sure the power supply for the DVI source is disconnected.

• Connect the cable from the DVI source to the input socket on the rear of the VideoPlex4.

• Connect the four displays to the output sockets on the rear panel of the VideoPlex4.

• Connect the VideoPlex4 power supply to the VideoPlex4 and switch on the power supply at the socket.

• Power up the DVI source.

The Power LED located on the front panel will light to indicate that power has successfully been applied to the unit.

The VideoPlex4 incorporates an internal processor that will continuously monitor the received DVI signal, and whenever a valid
and stable input is detected, the Input LED is illuminated.

If the Input LED is not lit, the VideoPlex4 cannot detect a valid DVI input source.

During operation, the VideoPlex4 adjusts its internal operation to maintain the programmed output proportions even when the
input resolution changes.

Input source

Output displayed

across all four screens

VideoPlex4

(VSC-VPLEX4)

Figure 3-1. Typical setup.