SMC Networks 1232 Series Manual De Usuario

  

15 

 

 

 

15

 

 
Connectors J1 and J2 carry the signals for the ISA Bus. These signals match definitions of the 
IEEE P996 standard. Below is shown a picture of the ISA BUS  

 

Figure 4. 

ISA BUS layout 

 
According to PC/104 specifications, KEYs are filled holes in the upper side and missing pins in 
the lower side of the bus connector. This is made to avoid the wrong insertion in/of another 
module. 
 
 
 

 
 

The ISA Bus connectors of the module are designed to allow the connection onto a stack of other 
PC/104 and/or PC/104Plus devices. We recommend you to follow the procedure below ensuring 
that stacking of the modules does not damage connectors or electronics parts. 
 
 

1.  Turn off power to the PC/104 system or stack. 

2.  Select and install standoffs to properly position the module on the PC/104 stack. 

3.  Touch a grounded metal part of the rack to discharge any accumulation of static electricity. 

4.  Remove the module from its anti-static bag. 

5.  Check that keying pins in the bus connector are properly positioned. 

6.  Check the stacking order; make sure an XT bus card will not be placed between two AT bus 

cards or it will interrupt the AT bus signals. 

7.  Hold the module by its edges and orient it so that the bus connector pins line up with the 

matching connector on the stack.