Intel CB60-ZX Manual De Usuario

2

Hardware Installation

23

2.7.12  Wake-On-LAN Connector

The system board supports the Wake-On-LAN function. This function

will allow the network to remotely power-on a Soft Power Down

(Soft-Off) PC. However, if your system is in the Suspend mode, you

can power-on the system only through an IRQ or DMA interrupt.

To use the Wake-On-LAN function, you must enable the “Resume on

LAN” field in the Power Management Setup of the  Award BIOS.

Your LAN card package should include a cable. Connect one end of

the cable to the wakeup header on the card and the other end to

location J15 on the system board. The network will detect Magic

Packet and assert a wakeup signal to power-up the system. Refer to

the add-in card’s manual for details. Note: Your LAN card must

support the remote wake up function.

Pin

1
2
3

Function

+5VSB (720mA)
Ground
WOL

Important:

The 5VSB power source of your power supply must support

≥

720mA (minimum).