Inova ICP-PII Manual De Usuario
©2001 Inova Computers GmbH
Page A-4
CPU Appendix-A
IPB-FPE8
Appendix A
J10A
J9A
J10B
J9B
J18B
J18A
J11
Figure A1.4 Piggyback Interface IPB-FPE8MS
Note that the IPB-FPE8 module does not allow a HD to be connected behind it and the lower 9-
pin D-Sub slot may be used for remote connection of PanelLink for example. The IPB-FPE8MS
shown in figure A1.4 enables connection of floppy, a CD-ROM and other peripherals. The connector
names and descriptions are declared in table A1.4.
pin D-Sub slot may be used for remote connection of PanelLink for example. The IPB-FPE8MS
shown in figure A1.4 enables connection of floppy, a CD-ROM and other peripherals. The connector
names and descriptions are declared in table A1.4.
Table A1.4 IPB-FPE8MS Connector Description
A1.4 IPB-FPE8MS (Theme Variation)
Figure A1.4 illustrates the construction of the IPB-FPE8MS - a variation of the IPB-FPE8 but with a
number of extra features. The electrical connection to the CPU base board is still via the underside
connector J11 and again, the precautions mentioned for the IPB-FPE8 are valid here.
number of extra features. The electrical connection to the CPU base board is still via the underside
connector J11 and again, the precautions mentioned for the IPB-FPE8 are valid here.
Connector
Description
J9A, J10A
IDE Primary (Master or Slave)
J9B, J10B
IDE Primary (Master or Slave)*
J11
Mouse, Keyboard and COM1
J18A, J18B
Floppy Disk (either a standard slim-line floppy connector or flex cable)
* If connectors 9a and 10a are configured as Master then 9b and 10b must be Slave.