Inova ICP-PII Manual De Usuario
©2001 Inova Computers GmbH
Page A-7
CPU Appendix-A
Appendix A
IPB-FPE8
CompactPCI
®
A
A1.8 COM1 Interface
The COM1 port features a complete set of handshaking and modem control signals, maskable
interrupt generation and high-speed data transfer rates. A front-panel with COM1, mouse and
keyboard interfaces is either integrated into an 8HP standard CPU front-panel or available as a
separate 4HP unit. The piggyback located behind these interfaces connects to the CPU-mounted
J11 connector.
interrupt generation and high-speed data transfer rates. A front-panel with COM1, mouse and
keyboard interfaces is either integrated into an 8HP standard CPU front-panel or available as a
separate 4HP unit. The piggyback located behind these interfaces connects to the CPU-mounted
J11 connector.
Figure A1.8 COM1 Interface Pinout
1
6
5
9
Table A1.8 COM1 Connector Signals
Note:
The standard CPU configuration has
COM1 set for RS232 communication.
However, this device can be configured to
observe a two-wire, non galvanically
separated, RS485 protocol. The data
separated, RS485 protocol. The data
direction is governed by controlling the
UART’s RTS signal. Writing a hex value of
0B to this register allows data to be
transmitted. Writing 1B to this register
configures the device to receive data.
RS232
RS485
1
DCD
2
RxD
RxD, TxD +
3
TxD
RxD, TxD -
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
RI
Pin No.
Signal